$6259.35
Using the Sprint Airfluid allows you to work directly out of the carton. Ideal for small batches and frequent paint changes. All parameters are set and saved via the EPGSprint X. In combination with the PEMX 1, perfect surfaces are achieved.
Included Items
-Corona manual gun PEM-X1
-Control device EPG-Sprint X
-Injector PI-F1
-Suction lance with fluid cap
-Device cart with vibrating table
-Powder hose 5m (Ø 11mm)
-Mains cable 3m
-Grounding cable 10m
-Connection hose
| Technical Data | |
| Input voltage | 85-250 V |
| Input power | 40 W |
| Input frequency | 50-60 Hz |
| Protection class | IP 64 |
| Air inlet pressure | 0.6-0.8 Mpa, 6.0-8.0 bar, 87-116 PSI |
| Air inlet connection | G 1/4″i |
| Exhaust air flow | 0.05-20.0 Nm3/h |
| Operating temperature | 5-45 °C, 41.0-113.0 °F |
| Weight | 38.0 kg, 83.8 lb |
Special Advantages
-Corona manual gun with an air-flushed high-performance cascade Constant and reliable coating performance
-Control unit with a regulated air volume cycle. A constant compressed air quantity despite fluctuations in the mains
-Fully electronic control unit for reproducible results Saving and accessing up to 50 coating programs
-Diagonal position of the powder container Powder carton is almost completely emptied
Processable Materials
-Polyester powder coatings
-Epoxy powder coatings
-Metallic powder coatings
-Acrylic powder coatings
-UDS powder coatings
-Effect powder coatings
